Table of Contents
Advertisement
a
502
503
505
515
560
561
563
564
Figure 3-4
Procedure
1. Remove the mounting plugs 502 and 503.
2. Turn the drive shaft 515 and clamping ring 560 of the gearbox to align them with the
mounting holes for the mounting plugs 502 and 503.
3. Apply adhesive (medium strength, e.g. Loctite 243) to the grub screw 564, screw 561 and
screws 505.
4. Secure the clamping ring 560.
5. Fasten the motor with the bolts 505 with the specified torque. See Section Thread sizes
and tightening torques for fastening bolts (Page 15).
6. Remove the fan cover.
BA 2019
Operating Instructions, 08/2018, A5E38094087A/RS-AE
Torque wrench
Mounting plug
Mounting plug
Bolt
Drive shaft
Clamping ring
Screw (component of Item 560)
Parallel key
Grub screw
Short coupling lantern with clamp connection
Installation
3.5 Mounting the motor
21
Advertisement
Table of Contents
