Table of Contents
Advertisement
Installation Instructions
Expansion card installation should be performed before installing
the V Panel Express system into an industrial cabinet or into a
control panel. Refer to the chapter "Accessing Internal
Components".
Leave sufficient space at the interface side for connecting the
peripheral devices.
Important Instructions!
If you mount the V Panel Express into an industrial cabinet, it is
advisable to use two people for the mounting, because the system
weighs approx. 11 kg (approx. 24,25 lbs).
Ensure there is sufficient air circulation around the device when
installing the V Panel Express. The openings for air intake and
exhaust on the device must not be obstructed.
Leave at least 5 cm (approx. 2".) of free space around the PC unit
to prevent the device from possibly overheating!
The voltage feeds must not be overloaded. Adjust the cabling and
the external overcharge protection to correspond with the
electrical data indicated on the type label.
The type label is located on the rear right hand side of the
system.
If you install the V panel into an instrument panel or other cabinet use the twelve
threaded M4 metric studs on the rear side of the front plate.
For the panel assembly, cut a window and twelve pre-drill holes according
Mechanical Drawings for V Panel Express 121/150/170 on the web page
www.kontron.com. The system must be attached firmly with twelve M4 metric
nuts. The contact surface with the rubber seal must be clean and flush.
V Panel Express – User's Manual
Installation Instructions
35
Advertisement
Table of Contents
