Starting Up
The DC power socket is located on the bottom side (rear) of the system.
The voltage of the power source must correspond to the
voltage value on the type label.
DC-Connection
The length of the DC connecting wires may not exceed 3m. Strip
and twist the connecting wire-ends but do not tin it the with solder.
Fig. 10: DC-connector (without Phoenix plug
terminal)
For the DC-connection prepare the connecting wires with the supplied Phoenix
plug. Pay attention to the right polarity of the wires (refer to Fig. 10 and 10a ).
The second end of each wire will be prepared as required for the connection to
the DC-power supply.
V Panel Express – User's Manual
Starting Up
Fig. 10a: DC-Terminal (Phoenix plug
terminal AWG 28-16)
29