Remote Control Operating Instructions; The Led Panel - UFO Star Series User Manual

4.2.2 Remote Control Operating Instructions

Power the unit on by pressing the ON/OFF button.
When the power is initially turned on, the UP/DOWN arrows control the power setting of the
heater. Adjust the heater to the desired power level before continuing with the timer settings.
When you press the CLOCK button, the UP/DOWN arrows are used to set the clock. Pressing
the arrows repeatedly accelerates or slows down the change interval.
Pressing the TIMER ON button lets you use the UP/DOWN arrows to designate a time when
you want your heater to come on. Pressing the TIMER ON button again saves that setting.
Pressing the TIMER OFF button lets you use the UP/DOWN arrows to set the time when you
want your heater to turn off. Pressing the TIMER OFF button again saves that setting.
Once the TIMER ON and TIMER OFF settings have been entered, you can press the EVERYDAY
button to repeat the on and off times on a daily basis. Unless cancelled or otherwise modified,
the TIMER ON and TIMER OFF settings you enter will be repeated every day. The unit must
be in STANDBY mode (plugged in) for timer operations to occur. The LED screen on the heater
body will flash continuously when any program is set via the remote control.
Pressing the SLEEP button allows you to operate the heater for a designated amount of time
before shutting off. Using the SLEEP function will override current TIMER ON/OFF programmed
settings, but will not cancel future programmed operations.
Pressing the CANCEL button clears each program entry. Wait three seconds between presses
to go back through your times.

4.2.3 The LED Panel

The LED panel on the body of the UK heater allows you to turn the unit ON or OFF and set
the power level. No programmed or timer operations can be initiated from the LED panel.
Pressing the ON/OFF button with the heater in standby mode will power the heater on at the
last-used power setting.
Pressing the MODE button changes the power setting. The LED will display that setting (H0,
H1, H2, H3, H4, etc.). If a programmed operation has been entered via the remote control
(above), the normal power display (HO, H1, etc.) will blink intermittently.
NOTE: If the heater is tilted, the LED will blink "Er" and the unit will beep until it is returned
to the horizontal position.
13