Uncrate The Waterfall - Plantronics Habitat Soundscaping Installation Manual

Uncrate the waterfall

Uncrate the
shipping
container
CAUTION: WHEN SERVICING YOUR WATER FEATURE MAKE SURE THAT YOU DISCONNECT ALL ELECTRICAL AND LIGHTING.
Enclosed Waterfall
Your waterfall ships inside of a wooden crate to protect the waterfall
from damage.
Your container indicates which side is the front of the waterfall.
1. Position the package so that the front is facing towards the ceiling.
2. Starting with the front panel of the shipping container, use the
drill with the No. 2 Phillips bit to remove all of the screws.
3. Remove the cardboard. The waterfall is wrapped in plastic and
surrounded by protective insulation foam. Remove the top layer
of insulation foam, but do not throw it away. You can reuse the
foam to protect the stainless steel while you move it into its final
position.
4. Remove the remaining wooden panel pieces and cardboard from
the shipping container.
5. Once all of the wood is removed, lift the waterfall to a standing
position. Leave the metal header off until the waterfall is in its
final position.
CAUTION Because the waterfall is very heavy, it is best to use
four people to move and position it.
6. Use the platform dollies to move the waterfall near its final
location, if necessary.
• To position the dollies under the base, tip the base on one
of the short edges. Roll one of the platform dollies under the
lifted base edge. Lower the base onto the platform dolly and
carefully tilt the waterfall so that the other dolly can be rolled
underneath the opposite side. Move the waterfall nearest to the
final location as possible.
• To remove from dollies, lift one side of the waterfall, remove
a dolly then rest the base onto the floor. Do the same for the
other side.
Midwest Tropical Inc • 3420 West Touhy Ave • Skokie, IL 60076 USA • Phone: (847)679-6666 • Fax: (847)679-6669
4