Table of Contents
Advertisement
Troubleshooting
Symptom
Uneven water
flow
Pump is loud/
has sucking
sound
Pump
unresponsive
Leaking water
Lighting
unresponsive
CAUTION: WHEN SERVICING YOUR WATER FEATURE MAKE SURE THAT YOU DISCONNECT ALL ELECTRICAL AND LIGHTING.
Enclosed Waterfall
Problem
Dry spots on panel
There is not
enough water
inside the panel
Pump auto start
off
Leaking water
Batteries are
depleted
Signal interrupted
Midwest Tropical Inc • 3420 West Touhy Ave • Skokie, IL 60076 USA • Phone: (847)679-6666 • Fax: (847)679-6669
Solution
Water flow is too low. Adjust the primary
control valve to increase flow to the spray bar.
Fill panel with more distilled water if the
water level is less than 4" above the base lid
when waterfall is powered on. (See page 8)
4 inches
Ensure there is enough distilled water in the
panel.
Without adequate water, the pump will suck
in air and produce bubbles or interruptions
in the water supply to the header.
Immediately disconnect power to the
waterfall.
Tighten all disconnect fittings above the spray
bar. Check seal at top of enclosed panel and
ensure screws are fully tightened.
Replace batteries in the remote control.
You may be too far away from the light fixture
when using the remote control:
•
Stand close to the waterfall and aim the
remote control downward at the base
The base lids may be interrupting the signal:
•
Remove base lids before using remote
control
13
Advertisement
Table of Contents
