Table of Contents
Advertisement
First-time operation
Adjust the flow
Adjust lighting
Seal the
waterfall
CAUTION: WHEN SERVICING YOUR WATER FEATURE MAKE SURE THAT YOU DISCONNECT ALL ELECTRICAL AND LIGHTING.
Enclosed Waterfall
Two valves control the flow of water and must be adjusted to balance
the flow at the top and base of the panel.
VIEW FROM REAR
Adjust the primary control valve to control the water flow
•
through the spray bar to create the waterfall effect. Adjust to
ensure that there are no dry spots on the panel.
•
Adjust the UV inlet valve flow until the fountain effect protrudes
approximately 1 inch above the water line on the left bottom side
of the panel.
Fountain effect
1 inch above waterline
If you have the optional lighting fixture, use the remote control to
customize the lighting. See pg 11.
Replace the header and base lids once you are satisfied with the water
flow and lighting.
Midwest Tropical Inc • 3420 West Touhy Ave • Skokie, IL 60076 USA • Phone: (847)679-6666 • Fax: (847)679-6669
Primary control valve
UV inlet valve
10
Advertisement
Table of Contents
