Roland Aproll MDX-540S User Manual page 90

5-5 Setting the Origins



88
Chapter 5 Handy Panel
Approx. 5 mm (0.2 in.)
USER(RML1) *READY
> X 100 .000
Y 50 .000
Z -30.000 S 0
[ ]
RATE x500 100%-XYZ
100%-S
If the ATC is installed, then grasp
the desired tool.
Place the tool sensor on the top
surface of the workpiece where you
want to set the Z-axis origin.
Move the tool to the area above
the tool sensor.
Close the spindle cover.
Press the [COORD. SYSTEM] key
several times to select the coordinate
system.