Starting Cutting - Roland Aproll MDX-540S User Manual

Starting Cutting

Overview of Operations
WARNING
In the NC-code mode, be sure to follow this procedure to perform output.
Direct output from a program, as in the RML-1 mode, is not possible. An error or
mistake here may result in unintended operation and is extremely dangerous.
Select it with care.
Step 1: Save the output file.
First, convert the NC program to a text file, then save it on the computer. This file is called the "output file." Saving
the cutting data as an output file is necessary even when you're using software such as a CAM program.
Step 2: Register and execute the output file.
Add the saved output file to VPanel's output file list, then specify execution. You can register (add) multiple output
files and execute them sequentially, one after another.
Starting Cutting
WARNING
Be sure to check carefully to ensure that the output file or files and the selected
command mode are correct, the locations of the origins are without error, and
the cutting parameters match the workpiece.
Errors or mistakes may cause the tool to break and be thrown off forcefully, leading
to danger of injury.
Procedure

4-4 Starting Cutting (NC-code Mode)
Make sure the machine is in the NC-
code mode.
P. 45 "3-3 Selecting the Command Mode"
Chapter 4 Getting Ready for and Performing Cutting
69