Roland Aproll MDX-540S User Manual page 83


To go back to the original screen, use the hand wheel to select [Return to main], then press the [ENTER] key.
Movement Destinations in the RML-1 Mode
 VIEW: VIEW position
 USER-XY: User coordinate origin
 MACHINE-XY: Machine coordinate origin
Movement Destinations in the NC-code Mode
VIEW: VIEW position
 G54-XY: Workpiece coordinate origin No. 1 (G54)
 G55-XY: Workpiece coordinate origin No. 2 (G55)
 G56-XY: Workpiece coordinate origin No. 3 (G56)
 G57-XY: Workpiece coordinate origin No. 4 (G57)
 G58-XY: Workpiece coordinate origin No. 5 (G58)
 G59-XY: Workpiece coordinate origin No. 6 (G59)
 EXOFS-XY: Location specified by EXOFS
 MACHINE-XY: Machine coordinate origin
<MOVE ME NU>
VIEW
> USER-XY
MACHINE-XY
[Return to main]
5-2 Moving the Tool
WARNING: This procedure
makes the machine operate. Before
you perform this procedure, check
to make sure that operation of the
machine will not create any hazard
or danger.
Press the [ENTER] key.
Chapter 5 Handy Panel
81