Roland Aproll MDX-540S User Manual page 68

4-3 Starting Cutting (RML-1 Mode)

Start output.
Important Safety Caution
When cutting start, check the state of operation, and if you sense danger, immediately press the
Emergency Stop button.
P. 40 "3-1 Emergency Stop to Ensure Safety"
An error or mistake may lead to danger of injury or fire. To ensure safety, be sure to observe the
cautions.
P. 6 "To Ensure Safe Use"
Cautions When Using the Machine with the Spindle in the Low-speed Range
Be sure to perform cutting at a spindle speed of 3,000 rpm or higher. Speeds of 400 to 3,000 rpm are for positioning and
centering. It is important to note that they are not suitable for cutting.
Using the Output File List
In the RML-1 mode, in addition to sending cutting data directly from the program, you can take cutting data that has been
made into a text file and import the file into VPanel. For more information, refer to the VPanel Online Help.
P. 23 "How to View the Online Help"
66
Chapter 4 Getting Ready for and Performing Cutting
WARNING: This procedure
makes the machine operate. Before
you perform this procedure, check
to make sure that operation of the
machine will not create any hazard
or danger.
Use the program to output the cutting
data.