Mains Water Connection; Information About Mains Water Connection - Miele FNS 28463 E ed/cs Operating And Installation Instructions

Mains water connection

Information about mains water
connection
The appliance may only be
connected to the mains water supply
by suitably qualified persons.
Disconnect the appliance from the
power supply before connecting it to
the mains water supply.
Turn off the water supply before
connecting the water supply line for
the ice-cube maker.
The water quality must conform to
the requirements for drinking water in
the country in which the appliance is
being installed (e.g. 98/83/EU).
The appliance must only be
connected to the mains drinking
water supply.
This appliance meets the requirements
of IEC 61770 and EN 61770.
Connection to the household water
supply must comply with the
applicable regulations in the country
in which the appliance is being
installed.
All units and systems used to supply
water to the appliance must also
comply with the applicable
regulations in the respective country.
The appliance is only suitable for
connection to a cold water line,
which
– is connected directly to the mains
water supply to guarantee circulation
of water in the cold water line.
68
Avoid connection to a water supply
in which the water might stagnate.
This can affect the taste of water and
ice cubes.
– withstands the operating pressure.
– complies with hygiene regulations.
The water pressure must be between
1,5 and 6 bar.
The stainless-steel hose supplied is
1,5 m long and must not be lengthened.
A faulty stainless-steel hose must
only be replaced by a genuine
original Miele replacement hose
(available from Miele or from your
Miele dealer). Ensure that the water
hose is suitable for drinking water.
A stopcock must be provided between
the stainless-steel hose and the
household water supply to ensure that
the water supply can be cut off if
necessary.
Make sure that the stopcock is still
accessible after the appliance has
been installed.