Mains Water Connection; Notes On Connecting To The Mains Water Supply; Preparing For Plumbing The Appliance Into The Mains Water Supply - Miele KF 1801 Vi Operating And Installation Instructions

Notes on connecting to the
mains water supply
Connection to the mains water
supply should only be carried out by
a qualified and competent person in
accordance with national and local
regulations.
This appliance has to be installed in
accordance with AS/NZS 3500.1
and AS/NZS 3500.2. The water
quality must conform to the
requirements for drinking water in
the country the appliance is being
installed in.
– This appliance meets the
requirements of IEC 61770 and
EN 61770.
– All parts used for connecting the
appliance to the mains water supply
must comply with current national
and local safety regulations in the
country in which the appliance is
being installed.
– The appliance is only suitable for
connection to a cold water supply.
– The water pressure (flow rate) must
be between 1.72 and 5.0 bar.
If the supply water pressure is
greater than 5.0 bar, make sure to
install a pressure reducing valve to
ensure 5.0 bar is not exceeded. The
maximum inlet water temperature
should not exceed 40°C.
– The stainless steel hose is 3 m long.

Mains water connection

– A tap must be provided between the
stainless steel hose and the
household water supply to ensure
that the water supply can be
disconnected if necessary.
The tap should be easily accessible
after the appliance has been built in.
Preparing for plumbing the
appliance into the mains water
supply
Plumbing connections must be
correctly in place before the
appliance is built in.
Before plumbing the appliance in,
ensure that it is disconnected from
the mains electricity supply.
Connection to the mains water supply
should incorporate a mains tap with a
3
/ " thread.
4
^ Connect the stainless steel hose to
the tap.
^ Ensure that it is screwed into position
correctly.
59