Preparations At The Workplace - Hilti SJD 6 Original Operating Instructions

5 Use of extension cords
WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord or extension cord if damaged
while working. Disconnect the supply cord plug from the power outlet.
▶ Check the appliance's supply cord at regular intervals and have it replaced by a qualified specialist if
found to be damaged.
• Use only extension cords of a type approved for the application and with conductors of adequate
cross-section. Otherwise the performance of the appliance may be affected and the cord may overheat.
• Regularly check the extension cord for damage.
• Replace damaged extension cords.
• When working outdoors, use only extension cords that are approved and correspondingly marked for
this application.
Recommended minimum conductor gauge (cross section) and maximum cable length with 120V
supply voltage
Extension cables
Extension cable conductor gauge
Extension cable conductor gauge
Extension cable length
Extension cable length
6

Preparations at the workplace

CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Fitting the saw blade
1. Disconnect the supply cord plug from the power outlet.
2. Push the saw blade (teeth facing the cutting direction) into the blade holder until it engages.
3. Grip and pull the saw blade to check that it is held securely.
6.2 Fitting the guard
▶ Push the guard onto the product from the front until it clicks into place.
6.3 Fitting the suction adapter
1. Push the suction adapter onto the base plate horizontally from the rear until both catches engage at the
side.
2. Connect the vacuum cleaner hose to the suction adapter.
6.4 Setting the orbital action
1. Determine the correct orbital-action setting for the task to be performed with the applicable saw blade.
2. Set the orbital-action adjusting lever to one of the four settings → page 5.
6.5 Adjusting the stroke rate
Determine the correct setting for the task to be performed with the applicable saw blade.
▶ Set the stroke rate regulator thumbwheel to a setting between 1 (low) and 6 (high).
*2150158*
Printed: 27.06.2019 | Doc-Nr: PUB / 5500683 / 000 / 00
AWG 16
1,31 mm²
2,58 kcmil
25 m
75 ft
3
4
5
6
7
2150158
AWG 14 AWG 12
2,08 mm² 3,31 mm²
4,11 kcmil 6,53 kcmil
30 m 50 m
100 ft 150 ft
AWG 10
5,26 mm²
10,4 kcmil
100 m
250 ft
English 7