Exit; Viewing Data From Connected Monitors - Honeywell EchoView User Manual

to a number outside of its assigned set of numbers. If you select an incompatible channel number,
you will see this screen, and then the EchoView returns to the Wireless menu.

7.2.5. Exit

To exit Wireless and return to the main Programming Menu, scroll until "Exit" is shown:
With "Exit" selected, press [MODE]. The EchoView now returns to the Programming Menu screen.

8. Viewing Data From Connected Monitors

You can view the data from each monitor on the network, even if the monitor is not in alarm.
To view the selected monitor's data, select the monitor you want to view. Scroll up or down the list
by using the [Y/+] and [N/-] keys.
To make your selection, press [MODE]. The screen changes to show the data. For example:
Monitor
Identifier
Sensor
Location
This provides you with an overview, including
• The monitor's location (if it has been programmed into the FMC2000 controller)
• The type of monitor
• The type of sensor
• The alarm state (NONE is shown when a monitor is not in alarm)
• The level or concentration of the substance being monitored (the unit depends on the type of
sensor)
To exit from this screen back to the main reading screen, press [MODE].
EchoView User's Guide
27
Alarm type
Sensor
reading