Turning The Echoview Off - Honeywell EchoView User Manual

Then the EchoView initializes the wireless network. When the network is found and communication
is established, the main reading screen is shown. It includes signal strength, battery charge, and
the identification numbers of all monitors on the network:
The monitor name shown on the EchoView screen is either the ID of the monitor's radio.
Important! Each name on a network must be unique. The automatically assigned radio ID is unique by
default.
Note: If no monitors are within the EchoView's range, its display will only show the radio-on indicator,
battery charge, and buzzer on/off icon.
If you see this screen, check the following:
• Is the antenna attached?
• Does the Pan ID match the network you want to join?
• Does the Channel match the channel on which the other instruments are operating?
• Are the other instruments turned on and within range?
• Did you change the Pan ID or Channel? If so, restart the instrument.
• Is the FMC2000 Controller's Pager Function enabled? If not, enable it.

5.3. Turning The EchoView Off

Hold down the [MODE] key through the "5...4...3... 2... 1... Power Off" sequence. The EchoView is
off when the display is blank. Release the [MODE] key.
The EchoView is now off.
EchoView User's Guide
14