Page Disable (Echoview Host) - Honeywell EchoView User Manual

Note: If you make a mistake, you can cycle through the digits by pressing [MODE] and then using
[Y/+] and [N/-] to change the number in each position.
Once all the four digits have been entered, press [MODE] again to see the following screen appear.
• Save your changes by pressing [Y/+].
• Exit without saving changes by pressing [N/-].
• Step back to the first digit by pressing [MODE].
Saving the password takes a moment, and a screen indicates that it has been successfully saved:

7.1.7. Page Disable (EchoView Host)

The Page feature can be enabled to allow up to four additional EchoView Host "mimic panels" to be
used as part of a closed-loop system.
When the Page feature is enabled, the EchoView Host broadcasts instrument data. These data can
be picked up by mimic panels. If no mimic panels are planned to be used, this feature should be
disabled, in order to ensure data privacy. Note: The default value is "Disabled."
To enable (or later to disable) the feature, press [MODE] to reach this screen (if it is already
enabled, it will say "Page Disable?):
EchoView User's Guide
22