Table of Contents
Advertisement
5. Operation
The EchoView only operates in RTR (Router) mode. Therefore, when it is turned on, it is always
operational.
Whenever you start EchoView, it tries to rejoin the last network it was part of. Therefore, if the
network is within range and if the channel and Pan ID have not changed, the EchoView should be
able to rejoin the network without action on your part.
Make sure the battery with sufficient charge is installed before operating the EchoView. Refer to
page 35 for information on battery installation and replacement.
5.1. Enable The FMC2000 Controller's EchoView
Function
The EchoView can only receive data from an FMC2000 Controller if the controller is configured to
broadcast data to it by enabling its EchoView Function. Therefore, you should perform this simple
configuration before adding one or more EchoViews to a network.
To enable the Pager function on the FMC2000 Controller:
1. Press the "MENU" key from Normal Operation Mode to enter the Configuration menu.
2. Provide a 4-digit password (the default value is 1234).
3. Press "Enter."
4. The "General Settings" icon is highlighted. Press "Enter."
5. Scroll to "Advanced Settings."
6. Press "Enter."
7. Input the advanced (6-digit) password.
8. Press Enter.
9. Input the 6-digit advanced password (the default is 123456).
10. Press Enter.
11. Scroll through the options until "EchoView" is highlighted.
12. Press "Enter."
13. Select "All Alm" (all alarms) or "SNS Alarm" (sensor alarms, including High, Low, etc.) by using
the up and down arrows. (There is also a "Disable" option that shuts off EchoView functionality.)
14. Press "Enter" to lock in your selection and exit the EchoView Function menu.
The FMC2000 Controller is now broadcasting its data for EchoViews.
EchoView User's Guide
12
Advertisement
Table of Contents
