Table of Contents
Advertisement
30
Using the EDS Mode
BANK D
Switches 1, 2, 3, 4: Page Length
Turn these switches on or off to form the pattern that matches the Page Length
setting you want to use.
Page Length
11"/Letter
8"
11.7"/A4
12"
8.5"/Letter
14"/Legal
10.5"/Executive
7.25"/Executive
3.5"
5.5"
Switch 5: CR Centering Position
If you set this switch OFF, the carriage moves to the center each time to feed
paper near the perforation. This way, you can get better quality of printing
around the perforations. It is recommended to match the page length setting to
your fanfold paper, otherwise, this function does not work properly at the
perforations.
If you leave this switch ON, the carriage does not move when feeding paper.
Switch 6 : Not used
BANK E
Switches 1, 2, 3, 4, 5: Code Page/International Character Set
If your EDS settings specify IBM emulation (Bank A, Switch 1 OFF) with
either character table (Bank A, Switch 2), or Standard emulation (Bank A,
Switch 1 ON) with the graphics character table (Bank A, Switch 2 ON), use the
Bank E switches to select the default character code page you want to use.
SW1
SW2
ON
ON
OFF
ON
ON
OFF
OFF
OFF
ON
ON
OFF
ON
ON
OFF
OFF
OFF
ON
ON
OFF
ON
SW3
SW4
ON
ON
ON
ON
ON
ON
ON
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
ON
OFF
ON
OFF
Advertisement
Table of Contents
Troubleshooting
