Device Management; Connecting To The Device - Siemens RUGGEDCOM RS950G Installation Manual

RUGGEDCOM RS950G
Installation Guide

Device Management

This section describes how to connect to and manage the device.
CONTENTS
• Section 3.1, "Connecting to the Device"
Section 3.1

Connecting to the Device

The following describes the various methods for accessing the ROS console and Web interfaces on the device. For
more detailed instructions, refer to the ROS User Guide for the RUGGEDCOM RS950G.
Serial Console Port
Connect a PC or terminal directly to the serial console port to access the boot-time control and ROS console
interface.
IMPORTANT!
The serial console port is intended to be used only as temporary connections during initial
configuration or troubleshooting.
The serial console port implements RS-232 DCE (Data Communication Equipment) on a DB9 connector. The
following is the pin-out for the port:
Figure 10: Serial DB9 Console Port
Connecting to the Device
5 1
9 6
Pin Name
1 DCD
2 RX
3 TX
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 Reserved (Do Not Connect)
Chapter 3
Device Management
Description
Data Carrier Detect
Receive Data
Transmit Data
Data Terminal Ready
Signal Ground
Data Set Ready
Request to Send
Clear To Send
15