Suitable Applications; Servicing And Repairs; Operating Warnings; Electrical Installation - Dimplex Quantum Series Installation Manual

SUITABLE APPLICATIONS

WARNING
used in any other type of environment. This product should only be used in the country
where it was purchased from by a recognised commercial retailer. Do not use outdoors.

SERVICING AND REPAIRS

WARNING
manufacturers approved service agent or a similarly trained or qualified person, using
only exact manufacturer approved spare parts.
PLEASE NOTE: Household dust, lit cigarettes, candles and oil burners, combined with
the convection effect of electric heaters can cause significant soot deposits to build
up on the surface directly above and to the sides of the heater. This is not a fault of the
heater. Extensive burning of candles or smoking in the operating environment of this
product can produce heavy discolouration within a few months of use.

OPERATING WARNINGS

IMPORTANT:
operating the heater on the automatic or timer modes, either attended or unattended
since a fire risk exists when the heater is accidentally covered, obstructed or displaced.
CAUTION:
Do not use if either of the heater's mains power leads become damaged. If
the supply cord is damaged it must be replaced by the installer or an approved Dimplex
service partner.
Do not sit or stand on the heater.
Ensure minimum clearances between the heater and other objects / surfaces are
maintained.

ELECTRICAL INSTALLATION

WARNING
accordance with the current wiring regulations.
Mains cables are not provided with this heater.
WARNING
suitably qualified or trained electrician, and be in strict accordance with current wiring
regulations.
The peak supply must be connected via a switched fused spur with a fuse rated suitably
for the appliances flex, the off-peak supply, via a 20A double pole isolated switch.
In both instances a plug and socket arrangement MUST NOT be utilised. The contact
separation to be a minimum of 3mm.
Failure to follow these instructions will mean that the manufacturer's instructions have
not been adhered to. THERE ARE NO EXCEPTIONS.
• This heater must be earthed
• Not suitable for connection via a plug top
• Do not locate the heater immediately above, below or in front of a fixed electrical point
i.e. socket outlet.
This appliance is intended for installation to a single phase supply only and is not suitable
for connection to 3 phase supplies.
- 3 -
- This heater is suitable for normal dwelling purposes and should not be
- Servicing and product repairs should only be undertaken by the
Remember to observe all safety warnings and precautions when
- Minimum clearances and IP zone requirements must be adhered to in
- The electrical installation of this heater must be carried out by a