Star Micronics NX-1001 User Manual page 99

Multi-font
Table of Contents

Advertisement

Power supply
If the POWER i ndicatordoesnot illuminate,check the following:
Check
Possible remedy
Is the power cable properly
Tum off the printer,make certainthatthe power cable
plugged into the electrical
is securely connected,andthenturntheprinterbackon.
outlet?
Is power being supplied to
Turn off the printer and unplug it. Try out another
the outlet?
appliamceoftheoutlettodetermin eifelectricity is being
suppliedto thatoutlet.
Is theprintervoltsgecomxt?
Checkthebottompanelof yourprintertoverify thatthe
outletvoltagecorrespondstothevoltagerequiredby the
printer. I f theydonotmatch, DONOT tryto operatethe
printer.
contact
your supplier.
PrhWng
If yourprinterdoesnot print,or suddenlystopsprinting,checkthe follow-
ing:
Check
Possible remedy
Is the interface cable con- 1 Check bothends of the cable - printerandcomputerto
nected securely?
make sure thatthe connector is firmly in position.
Is the ONLINE indicatori.llu-
Ifit isno~press the ONLINE buttontoset theprinteron-
minated?
line.
Is the POWER indicator I If it is, the paperhas runout. Loadmore paper.
flashing?
Is the papercaughtup inter-
Turnoff thepower,remove thejammedpaper,replace,
nrdly?
tumontheprinter,andcontinueprinting. M akesurethat
the leading edge of the paperis smooth anduncreased.
Is the ribbon caught up
Turnoff thepower,remove thenbbon, retensionit, and
aroundthe printhead?
replace it. This problemoccurs most frequentlywith a
wornribbow so you may need to replace the ribbon.
Is the softwareyou areusing
Checkthe installationsettings in yoursoftware, andre-
properly installed for your
install ifn~ssary.
printer?
Canthe printerperformself-
Turnthe printeroff, andtum it on again,holdingdown
test operations?
one of the buttonsto performa self-test. If these do not
work, contactyour &aler.
90

Advertisement

Table of Contents
loading

Table of Contents