Table of Contents
Advertisement
I
If the paperpark facilitydoesnot appearto be workingcorrectly,checkthe
following:
Check
Possibleremedy
Is the paper release lever in
Thepaperrelease Ievermustbe set to the * position
the * position?
afterthefanfoldpaperhas beenparked.
Has the fanfoldpaper been
Makesurethatthe
POWERindicatorcomes on flashing
properlyparked?
afterthe fanfoldpaperhaabeen parked.
If text is beingprinted all on one line, or with extra blanklines, checkthe
following:
Check
Possible remedy
Is the text alt on the same
Carriage returns are not being expanded to
tie?
cCR> +<LF>pairs. Checkthe DIP switch setting and
correct.
Is text being printed with
Two line feeds arebeing printed.Makeyour software
extrablanklines?
printjust acarriageretttrnor (if thisisnotpossible), set
the AUTO LF to OFF with the DIP switch setting.
If thepagelengthandmarginsarenotwhatis expected,checkthefollowing:
Check
Possibleremedy
Is the printing starting too
Usethe Micro Feed functionto adjusttheprintposition
high or too low on the page?
relative to the page.
Does the printer's page
Use the DIP switch to setup the correctpage length, or
lengthnotmatchthephysical
use software commandsto do it.
page length?
94
Advertisement
Table of Contents
