Haier FlexFit Pro Series Service Manual page 89

FlexFit Pro
d. Then after step c and it will show the speed of the compressor rotor, 000 stands for speed is 0 RPS, 15 stands
for 15 RPS, 49 stands for 49 RPS, and so on.
e. After Step D, when the indoor temperature reaches the set point, the outdoor unit will shut off and the LED
display will be 000. 30 seconds later the LED will shut off. If the unit is shut off manually via the controller, the
LED will display OFF for 30 seconds then will go out.
5.4 Checking the Parameters
Step1: Press and hold the MODE button for 5 seconds and release, then The LED display will show the current
mode and will be flashing.
Step2: Press and hold the SET button for 3 seconds then release, The LED display will keep MODE lighted without
flashing..
Step3: Press and hold the SET button for 3 seconds again then release, The LED will display FRQ and will flash
the present speed of the compressor.
S t e p 4 : S c r o l l p a g e s t o v i e w t h e o t h e r p a r a m e t e r s b y u s i n g U P o r D O W N b u t t o n
Fig. 4.1 or Fig. 4.2 shows steps above.
85