Haier FlexFit Pro Series Service Manual page 109

FlexFit Pro
Loading of the battery
Note:
The distance between the signal transmission head and the receiver hole should be within 7m without any obstacle as well.
When electronic-started type fluorescent lamp or change- over type fluorescent lamp or wireless telephone is
installed in the room,the receiver is apt to be disturbed in receiving the signals,so the distance to the indoor unit
should be shorter.
Full display or unclear display during operation indicates the batteries have been used up. Please change batteries.
If the remote controller can't run normally during operation, please remove the batteries and reload several minutes later.
Hint:
Remove the batteries in case won't be in use for a long period. If there is any display after taking-out, just press reset key.
Functional description:
1. Power-up and Show All: the LCD display shows all symbols in this function. 3s later, it just shows time and the
initial time is AM 12:00. The initial time is adjustable and will be confirmed automatically 10s later.
2. ON/OFF Button: press the button for power on. The initial default mode is SMART, otherwise it will be the mode
before power OFF. Press OFF button after power on.
3. SMART Button:
(1) SMART button is always valid during power ON/OFF;
(2) Press SMART button to execute power OFF in SMART mode;
(3) In OFF and other modes, press SMART button to enter initial default setting of SMART mode. LCD setting
temperature is not showed;
(4) In SMART mode, press TEMP. +/- button to show the setting temperature.
4. COOL Button, HEAT Button and DRY Button
(1) When the remote controller in ON, press COOL button, HEAT button and DRY button to execute COOL mode,
HEAT mode and DRY mode.
(2) For initial power-up, temperature and fan speed will be showed as follows when entering each mode, otherwise
parameters set last time will be showed;
Mode SMART
Initial TEMP. 24°C
Mode SMART
Initial Fan Speed AUTO
5. FAN Mode
(1) During power OFF, press "HEALTH" button or "FRESH" button to enter FAN mode with low fan speed.
Meanwhile, the HEALTH or FRESH icon will be showed on the screen.
(2) Temperature is not showed in FAN mode.
(3) Auto fan speed is not available when switching fan speed in FAN mode.
6. FAN SPEED Button:
(1) In other modes except for Fan mode, LOW, MED, HI and AUTO fan speed is adjustable, switching sequence is
as LOW-MED-HI-AUTO-LOW.
1.Remove the battery cover
2.Insert 2 AAA batteries as illustrated noting battery polarity
3.Reinstall the battery cover
HEAT COOL
24°C 24°C
HEAT COOL
LOW HI
LOW, MED and HI fan speed circulate automatically
105
DRY
24°C Setting temperature is not showed.
DRY
AUTO
FAN
FAN
LOW