Bottom Feeding Delta-15 - Star Micronics Delta User Manual

A Closer Look
11
9. Return the paper separator to its original flat position,
10. Pull the paper up, past the sprocket units.
11. When holes fit snugly over the nubby teeth in both sprockets,
close the tractor covers and snap the clamp levers back into
their locked position (Figure l-10).
12. With the platen knob, roll the paper up or down until the cor-
rect "start-print" position is reached. You do this by lining up
the horizontal perforation (where you tear apart individual
sheets] with the top of the ribbon guide (as shown in Figure I-
ll).
13. Now you're ready to roll! Replace the printer cover and turn
the power switch on. Rapid printing!
Figure I-10. Delta ready to run with sprocket-feed
paper.
Bottom feeding Delta-15
The Delta-15 can be loaded with sprocket paper in two
different ways-either from the back, as with Delta-lo, or through
a slot in the bottom. To load Delta-15 from the back, follow the
steps shown in the previous section. But for loading through the
bottom slot, you position the Delta-15 above the stack of fan-fold
paper, with the paper being fed up through the bottom of the
printer and on out the back.