Star Micronics Delta User Manual page 18

6
Delta User's Manual
Paper press bar
\
Release lever
'- __
'igure l-5. Inserting
a single sheet ofpaper can be done "under power" with the
ne feed button.
Now, instead of rolling the paper in
manually
by turning the
platen knob, we're going to use the L.F. button, with the power
switch turned on. (This means we'll have to use the "F" (friction
feed) position of the release lever.) Remember what we told you
about that L.F. (line feed) button? This allows you to advance the
paper one line at a time, and if you hold the button down, you'll
get multiple line feeds, one after the other.
OK? Now let's start.
--
-
-
1.
Remove the printer cover and tractor unit (you can leave the
paper guide and paper separator on if you have installed
them).
_
2. Turn the power switch on.
3. Lift up the paper press bar.
4. Set the release lever to the "F" position.
5. Insert the sheet from the back side of the platen (between the
paper chute and the platen cover plate).
6.
Press the ON LINE button until the ON LINE light goes off.
7. Press the L.F. button to roll the paper in until it appears on the
front side of the platen, about where you want the first line to
start printing.
__
-
_