Table of Contents
Advertisement
Wiper/Washer Lever
1 — Push Forward For Rear Washer
Operation
2 — Rotate Lever Upward For Front
Wiper Operation
3 — Move Lever Up To Mist
4 — Rotate Ring Upward For Rear Wiper
Operation
5 — Pull Rearward For Front Washer
Operation
20
Windshield Wiper Off
This is the normal position of the wiper lever: O.
Intermittent Wiper System
Intermittent Low Speed —
Rotate the end of the lever upward to the first
detent for low intermittent speed to operate the
wipers with a fixed pause of ten seconds.
Intermittent High Speed —
Rotate the end of the lever upward to the second
detent for high intermittent speed to operate the
wipers with a delay that is dependent on the
speed of the vehicle.
Low Continuous Speed — LO
Rotate the end of the lever upward to the third
detent to operate the wipers at a low continuous
speed.
High Continuous Speed — HI
Rotate the end of the lever upward to the fourth
detent to operate the wipers at a high continuous
speed.
Front Windshield Washer Operation
Pull the windshield wiper/washer lever toward
the steering wheel to activate the washers. The
wipers will activate automatically for three cycles
after the lever is released.
CAUTION!
• Turn the windshield wipers off when driving
through an automatic car wash. Damage to
the windshield wipers may result if the
wiper control is left in any position other
than off.
• In cold weather, always turn off the wiper
switch and allow the wipers to return to the
park position before turning off the engine.
If the wiper switch is left on and the wipers
freeze to the windshield, damage to the
wiper motor may occur when the vehicle is
restarted.
• Always remove any buildup of snow that
prevents the windshield wiper blades from
returning to the off position. If the wind-
shield wiper control is turned off and the
blades cannot return to the off position,
damage to the wiper motor may occur.
Advertisement
Table of Contents
