Replacing The Filter - Teka CLC User Manual

9. "HOT WATER PRESS OK" is displayed.
10. Press the OK button (B9)
The appliance begins delivering hot water
and the message "PLEASE WAIT" is di-
splayed.
After the flow of hot water stops, the ap-
pliance automatically resets to "READY"
status.
Replacing the filter ("Filter
Reset")
When "REPLACE FILTER" is displayed or after
2 months of use (see date indicator), the filter
must be replaced:
1. Remove the exhausted filter;
2. Remove the new filter from the packaging.
3. Slide the pointer of the date indicator (see
fig. 28) until the months of use are displayed
(the filter lasts about 2 months).
4. Insert the filter in the water tank and press it
until it touches the bottom of the tank (see
fig. 28).
5. Fill the water tank and insert in the coffee
maker;
6. Turn the cappuccino maker outwards and
place a container underneath (min. capacity
100 ml).
7. Press the MENU button (B6) to enter the
menu;
8. Press the NEXT button (B7) until "FILTER
RESET NO" is displayed.
9. Press the CHANGE button (B8) until "FILTER
RESET YES" is displayed.
10. Press the OK button (B9) to confirm.
11. "HOT WATER PRESS OK" is displayed.
12. Press the OK button (B9) again. The ap-
pliance begins delivering hot water and the
message "PLEASE WAIT " is displayed. After
the flow of hot water stops, the appliance au-
tomatically resets to "READY" status.
Removing the filter
If you want to use the appliance without a filter,
you must remove it and notify the appliance of
its removal as follows:
1. Press the MENU button (B6) to enter the
menu.
2. Press the NEXT button (B7) until "UNIN-
STALL FILTER" is displayed.
3. Press the OK button (B9). The appliance au-
tomatically resets to "READY" status.
TURNING ON AND HEATING
UP
Each time the appliance is turned on, it performs
an automatic preheat and rinse cycle which can-
not be interrupted. The appliance is ready for use
only after completion of this cycle.
Danger of burns! During rinsing, a little
hot water flows from the coffee spouts.
Avoid contact with splashes of water.
To turn the appliance on, turn the knob
(to the right or left) (fig. 5). "HEATING UP PLE-
ASE WAIT" is displayed.
After heating, the message "RINSING "PLEASE
WAIT" is displayed. As well as heating the boiler,
the appliance also heats the internal circuits by
circulating hot water.
The appliance is at temperature when the mes-
sage "READY STANDARD TASTE" is displayed.
MAKING COFFEE USING
COFFEE BEANS
1. The appliance is preset to make coffee with
a standard taste. You can also choose cof-
fee with an extra-light, light, strong or ex-
tra-strong taste.
To choose the required taste, press the
button (B2) (fig. 6). The required cof-
fee taste is displayed.
2. Place 1 cup under the spouts to make 1 cof-
fee (fig. 7) or 2 cups for 2 coffees (fig. 8).
Lower the spouts as near as possible to the
cup for a creamier coffee (fig. 9).
3. Press the
coffee, the
coffee and the
coffee (fig. 10). To make 2 coffees, press
10
button (B3) to make a short
button (B4) for a standard
button (B5) for a long
(A7)