Exit Burn-In Mode; If Unable To Exit Burn-In Mode; Osd Controls; Osd Keypad - Emerson RXi User Manual

User Manual
GFK-3065 Rev. A
3.1.2

Exit Burn-in Mode

Before exiting burn-in mode, please first disconnect the AC power cord, then press the
reason this button is non-functional, press and hold the
Do not release the button until the AC power cord is connected again and the wording of "RGB" appears on
the top left corner of your screen, then wait for 3 seconds. If there is no input plugged into the unit, the
"CABLE NOT CONNECTED" message will denote that it has successfully left burn-in mode.
3.1.2.1

If unable to exit Burn-in Mode

If the "RGB" is still on the top left corner of the screen, press
and then select "Yes", and press
steps.
If the "RGB" is not found, disconnect the AC power cord first, then press and hold the
the AC power cord is connected, and wait for 2 to 3 seconds. When "RGB" appears, repeat the above steps.
3.2

OSD Controls

3.2.1

OSD Keypad

To make any adjustment to the settings of the Industrial Monitor, select the following:
1. Press
2. Select the icon that you wish to adjust with the (
3. Press
4. Press
OSD
. When the screen goes black, disconnect power and repeat the above
(Menu) to show the OSD menu or dismiss the OSD menu.
(Menu) and then choose the item with the (
(Menu) and then adjust the quality with the (
button) until the AC power cord is connected.
to enter "Miscellaneous" and choose "Reset",
/ or +/-) key in the menu.
/ or +/-) key.
/ or +/-) key.
Section 3
May 2019
button (If for any
buttons until
31