Jumpers And Connectors Location; Connecting Input Power (24V Dc-In) - Emerson RXi User Manual

User Manual
GFK-3065 Rev. A
2.2

Jumpers and Connectors Location

Figure 2.2
2.2.1

Connecting Input Power (24V DC-in)

To connect to power, follow these steps:
1. Verify that the power cable is not energized.
2. Loosen the screw clamps on the mating power connector.
3. Strip the insulation from the power cables.
4. Secure the power cable to the mating connector, noting polarity, and tighten the screw clamps. The
torque for the attaching screws is 0.3 Nm (2.26 in-lb).
5. Apply dc power to the unit. During normal startup and operation, the LED status indicator displays as
follows:
6. Once power is applied, the unit begins initializing. The first thing to display is the splash screen.
Be sure to connect a DC power cord to this 3-pin power connector. Using a voltage out of the range may fail
to boot the system or cause damage to the system board.
Hardware
Jumpers and Connectors Location
•
Solid amber while the RXi Industrial Display unit is starting up
•
Solid green during normal operation
Section 2
May 2019
21