Fitting The Batteries; Instructions For Use - KERO 262 Instructions For Use Manual

Prepare the heater for use by carrying out the instruction in
the following order:
1. Unpacking
Remove the heater from the cardboard box.
Remove the sticky tape from the protection grid and open it
as described below:
1. Pusch the grid upwards.
2. Pull the bottom of the grid facing you.
3. Pull the grid downwards.
Reverse the process to install the grid.
Remove the packing material from the conbustion cylinder.
Open the lid of the fuel tank compartment and remove the
material which protected it during transport.
2. Fitting the combustion cylinder
Place the combustion cylinder on the circular wick guide.
Turn the combustion cylinder lever to the left and then half
way to the right until the combustion cylinder is correctly
positioned in the circular wick guide.

3. Fitting the batteries

Unscrew the batteries case protection
the battery case and then place 2 batteries in the battery
case at the rear of the heater. Make sure that you respect
the polarities +/- as indicated in the drawing. Screw the bat-
teries case protection.
ATTENTION: some batteries
can damage the lighter

INSTRUCTIONS FOR USE

, take off the top of
strong voltage or power
IMPORTANT: DANGER:
•
Never remove the batterie while the heater is
operating
•
Make sure of the quality of your batteries
•
Never light your heater with matches or a lighter
other fire.
56
Move from side to side
or