Fitting The Batteries - KERO 260 Instructions Manual

INSTRUCTIONS FOR USE
Prepare the heater for use by carrying out the instruction in
the following order:
1. Unpacking
Remove the heater from the cardboard box.
Remove the sticky tape from the protection grid and open it
as described below:
1. Pusch the grid upwards.
2. Pull the bottom of the grid facing you.
3. Pull the grid downwards.
Reverse the process to install the grid.
Remove the packing material from the conbustion cylinder.
Open the lid of the fuel tank compartment and remove the
material which protected it during transport.
2. Fitting the combustion cylinder
Place the combustion cylinder on the circular wick guide.
Turn the combustion cylinder lever to the left and then half .
way to the right until the combustion cylinder is correctly
positioned in the circular wick guide.
I------../"-
~
1-/ -).
J - - -
3. Fitting the batteries
Unscrew the batteries case protection then place 2 batteries
in the battery case at the rear of the heater. Make sure that
you respect the polarities +/- as indicated in the drawing.
Screw the batteries case protection.
IMPORTANT: DANGER:
• Never remove the batterie while the heater is
operating
• Make sure of the quality of your batteries
• Never Iight your heater with matches or a Iighter
56