Lighting The Heater - KERO 262 Instructions For Use Manual

Before you light the heater, check the
following points:
The combustion cylinder must be proprely positioned. Make
it rotate pushing the lever from left to right and make sure it
is correctly fitted.
When you use the heater for the first time, odours may
persist for a certain time after lighting. This is normal, as oil
and protective grease in the heater have to be burnt off.
Slowly push the ignition lever downwards until it stops and
keep the knob downwards. The wick will rise and the heater
ignites automatically. Check visually that the heater is alight.
After having carried out the ignition procedure, there may be
some white smoke coming out of the ignition zone, without
the heater being lit. In this case, move up the ignition lever
part way through its travel and the heater will start to
operate. This operation must be done slowly and gently.
Try several times if lighting is not carried out in the 2 or 3 se-
conds. In the event of insistence, you risk to roast the lighter
or the wick (spare parts non garanty).
CAUTION: NEVER LIGHT YOUR HEATER WITH
MATCHES OR A LIGHTER

LIGHTING THE HEATER

OR OTHER FIRES
60
Move from side to side