KERO 262 Instructions For Use Manual page 9

TURNING OFF YOUR HEATER
For a shut-off push the "STOP button". The automatic shut-off device against knocks will
automatically be activated, it will lower the wick very quickly and also put out the flame.
It is possible that an excess accumulation of carbon and other deposits on the wick will
prevent proper operation of the automatic shut-off device. Make always sure to visually
check that the automatic shut-off device has operated proprely.
When lighting the heater again
Precautions:
After turning off the heater, wait at least five minutes before lighting the heater again. If
the combustion cylinder has not had time to cool down, lighting the heater again may
result in odours being given off.
This heater has been designed with an Airsensor device
the direct measure of CO2 in the room.
Abnormal conditions of use of your heater (bad ventilation or too
small a room) will automatically provoke the shut-off of your
heater .
Do not try to light on again your heater. Wait that the temperature
of the room goes down and renewal of air., th heater will light on
itself.
Airsensor Detector
62
based to