Table of Contents
Advertisement
262, 362
INSTRUCTIONS
Français
................... 5
Español ....................... 25
Nederlands .................. 35
Deutsch ...................... 45
English ........................ 55
Português .................... 65
Italiano ....................... 75
Norvegian ................... 85
Dansk .............................. 95
Advertisement
Table of Contents
Related Manuals for KERO 262
Summary of Contents for KERO 262
- Page 1 262, 362 INSTRUCTIONS Français ………………. 5 Español ………………….. 25 Nederlands ……………… 35 Deutsch …………………. 45 English …………………... 55 Português ……………….. 65 Italiano ………………….. 75 Norvegian ………………. 85 Dansk ......95...
-
Page 2: Specifications
SPECIFICATIONS MODEL BRANDNAME KERO HEATER TYPE PORTABLE RADIANT TYPE HEATING OUTPUT 2400 3000 FUEL CONSUMPTION RATE 200 g/h 0.25 L/h 250 g/h 0.31 L/h CONTROL HEATING TIME +/- 16 h +/- 15 h FUEL TANK CAPACITY 4.0 l 4.6 l... -
Page 3: Fitting The Batteries
INSTRUCTIONS FOR USE Prepare the heater for use by carrying out the instruction in the following order: 1. Unpacking Remove the heater from the cardboard box. Remove the sticky tape from the protection grid and open it as described below: 1. - Page 4 LIQUID COMBUSTIBLE FOR MOBILE HEATER Type of liquid combustible for mobile heater We advise you to use the or better the More than 95 % of problems are due to using a wrong type of liquid combustible for mobile heater. Those problems are not covered by our warranty. Only top-quality liquid combustible for mobile heater, according to the law of 08/01/98 and 18/07/02...
-
Page 5: Reading The Fuel Gauge
Reading the fuel gauge Presence of liquid combustible for mobile heater will make move the reading on the gauge into the black. Liquid combus- Quantity Too much Stop filling when the liquid combustible for mobile heater tible for mobile of fuel is fuel heater level almost... - Page 6 PREPARING TO LIGHT THE HEATER Levelling the heater Make sure that the heater is standing on a level surface. If the heater is not level, the automatic shut-off device maybe prevented from working. Automatic shut-off device in case of knocks Push the ignition lever downwards untill it stops.
-
Page 7: Lighting The Heater
LIGHTING THE HEATER Before you light the heater, check the following points: The combustion cylinder must be proprely positioned. Make it rotate pushing the lever from left to right and make sure it is correctly fitted. When you use the heater for the first time, odours may persist for a certain time after lighting. - Page 8 Adjusting the height of the flamme Combustion can be optimized within a range of 10% by adjusting the height of the flame (see hereafter). Go up a little the button of adjustment to decrease the combustion. Bad combustion Good combustion Bad combustion Insufficient heating of the Flame is dangerously...
- Page 9 TURNING OFF YOUR HEATER For a shut-off push the "STOP button". The automatic shut-off device against knocks will automatically be activated, it will lower the wick very quickly and also put out the flame. It is possible that an excess accumulation of carbon and other deposits on the wick will prevent proper operation of the automatic shut-off device.
- Page 10 IMPORTANT Any tampering with or modification to the safety system is prohibited. Apart from invalidating the guarantee, this would risk causing a failure of the system which is there for your safety. RESTRICTION ON USE This heater may not be used in rooms which are hermetically sealed, such as caravans, boats, passenger compartments of vehicles etc.
-
Page 11: Troubleshooting Guide
TROUBLE SHOOTING GUIDE In case of problems, check here before you take your heater to your dealer. Possible cause Solution Batteries may be Replace the batteries. flat or weak Ignition plug Replace ignition plug. filament may be bent or broken Wick is too low, Use wick adjustment knob to too high or...