Advertisement
GAMMA instabus
Technical Product Information
March 2008
DELTA profil
Display and control unit
DELTA style
Display and control unit
DELTA ambiente
Display and control unit
Connecting the bus cable (Diagram 4)
− The bus terminal (D2) is suitable for single-core con-
ductors with 0.6 ... 0.8 mm Ø.
− The bus terminal (terminal block) (D2) consists of two
components (D2.1, D2.2), each with four terminal
contacts, Diagram 7.
− Strip the insulation from the conductor (D3) and place
in the terminal (D2) (red = +, grey = -).
Diagram 4: Connecting the bus cable
Installation of the display
B4
B5
B6
B1 Driver with bus connection
B2 Frames
B3 Intermediate frame (only for DELTA style)
B4 Display unit
B5 Screws for fixing the display unit onto the
driver B1
B6 Cover
Place the display unit (B4) with B6 and the relevant
-
frame (B2) onto the driver (B1).
Remove the cover (B6) from the display unit as de-
-
scribed under 'Dismantling' in order to program the
physical address.
Secure the display unit (B4) with the two screws (B5).
-
Technical Manual
Update: http://www.siemens.com/gamma
2.3.1.2/4
UP 585
UP 584
UP 586
B1
B2
B3
UP 58x, 6 pages
© Siemens AG 2008
Subject to change without prior notice
Now program the physical address.
-
The location of the programming button and the pro-
gramming LED is indicated in Diagram 5.
Remove the protective film from the LC display,
-
Diagram 6c.
Place the cover (B6) on the display unit again (B4).
-
Location of the programming button and
programming LED
Diagram 5: Location of the programming button and LED
is also indicated on a non-configured LCD if
bus voltage has been applied
Dismantling
Remove the cover as described in Diagram 6a or 6b.
-
Caution:
Do not touch any components apart from the program-
ming button (Diagram 6) as damage could otherwise be
caused.
Loosen the fixing screws (B5).
-
Place the cover (B6) back on the display unit (B4).
-
Remove the frame (B2) together with the display unit
-
from the driver.
Loosen the screws of the driver in the flush-type box
-
(Diagram 3).
Separate the bus driver module from the bus cable
-
(Diagram 7).
P.O. Box 10 09 53, D-93009 Regensburg
5WG1 585-2AB_1
5WG1 584-2AB_1
5WG1 586-2AB_1
Program-
ming LED
Programming-
button
Siemens AG
Automation and Drives Group
Electrical Installation Technology
Advertisement
