Advertisement
D E S C R I P T I O N O F F U N C T I O N S
affect the operation of the fader. Clean
the slider assembly by gently wip-
ing the wiper contacts and slider
bearings (E) using a tissue or cot-
ton bud. If slider bearings are
excessively worn, as indicated by
excessive slider rocking then con-
tact Stanton for replacement.
3. Remove the single upper screw on
the opposite end block to remove the guide rail.
Clean the guide rail (F) with a tissue or cloth,
removing all traces of dirt and contamination.
4. Remove the fader track (G) by slowly withdraw-
ing from the unit. Place fader track on desk or
working surface with black contacts facing upwards. If necessary,
the track can be washed in warm water, wiped gently then dried
thoroughly using a dry cloth. Use a lint free cloth or swab to wipe
the tracks and check for marks along the track. (Note: Lint free
cloth should be used to avoid dust/fibers being deposited on the
track). If the track appears excessively worn, or if cleaning does
not improve operation, replacement may be necessary.
5. Examine the center channel of the fader body and if dirty, clean
using cotton buds.
6. Re-assemble and lubricate the fader as follows:
6.1) Secure the end block and guide rail onto the fader body.
6.2) Insert track into the fader body.
6.3) Insert slider assembly onto guide rail and into the fader body. Move slid-
er from end to end to disperse the oil evenly. Carefully wipe away any excess
oil using a tissue or cloth.
6.4) Lubricate the guide rail by placing one drop of silicon liquid oil onto the
guide rail (F).
6.5) Insert dust cover.
6.6) Insert fader track back into fader body with wires coming out open end of
fader body.
6.7) Secure the remaining end block ensuring that the track wires (I) are not
pinched between the end block and fader casing.
7. Once assembled, move the slider from end to end to ensure operation is
smooth.
8. Attach fader to fader plate. (NOTE: As noted earlier if you do not want to
change positioning of fader, keep the 2 fader plate screws loose and shift the
fader until it is aligned with the marks you created in step 1, then tighten fader
plate screws.)
B
A
G
C
F
E
D
G
I
Advertisement
