ROTATING AND REPLACING THE OS2
ROTATING INSTRUCTIONS
1 . Remove the face plate.
2. Remove the 2 outer screws from the
round OS2 plate (removing the 2 inner
screws will detach the fader from the
plate)
3. Rotate the plate to the desired posi -
tion and tighten the screws back into
the top and bottom holes.
W A R R A N T Y
This unit has been designed and man -
ufactured using quality components.
Therefore, it is warranted to be free
from defects in materials (limited as
specified below), and workmanship for
a period of twelve (12) months from the
original purchase date. During this
period, all service and parts necessary
to repair a defect will be free of charge.
This
limited
warranty
applies
mechanical parts which are subject to
wear and tear as specified: Faders,
specified durability: 15,000 cycles;
Rotary potentiometers, specified dura -
bility: 10,000 cycles; Switches, speci -
fied
durability:
10,000
© 2001, Stanton Magnetics, LLC
REPLACING INSTRUCTIONS
1. Remove the the face plate.
2. Remove the 2 outer screws from the
round plate (removing the 2 inner
screws will detach the fader from the
plate)
3. Remove the OS2 assembly and dis -
connect the cable coming from the
mixer.
4. Set the replacement fader assembly
in the desired position and place the
screws back in the top and bottom
holes.
Consequently, the parts listed above
are warranted to be free from defects in
materials and workmanship for a peri-
od of thirty days (30) days from the
original purchase date.
For the warranty to be valid, please
complete the warranty registration card
attached or fill out the online registra -
to
tion
at www.stantonmagnetics.com
Mail completed warranty cards to:
Stanton Magnetics, Inc, 3000 SW 42st
cycles.
• Hollywood, FL 33312
SA-12
D J C R A Z E S I G N A T U R E M I X E R
OWNER'S MANUAL
STANTON MAGNETICS, INC
info@stantonmagnetics.com • (954) 689-8833
w w w . s t a n t o n m a g n e t i c s . c o m