Stamina T3000 Treadmill 45-1003 Owner's Manual page 8

ASSEMBLY INSTRUCTIONS
STEP 2
Place the BASE FRAME(1) between the LEFT and RIGHT UPRIGHTS(2, 3) and secure with HEX
BOLTS(M12x1.75x75mm)(35) and WASHERS(M12)(45). DO NOT TIGHTEN COMPLETELY.
STEP 3
Slide down the upper parts of the FOAM GRIPS(22), so you can see the screw holes at the back side of the
tops of the LEFT and RIGHT UPRIGHTS(2, 3). Connect the UPPER EXTENSION WIRE(26) to the LOWER
EXTENSION WIRE(27). Insert the U-SHAPED HANDRAIL(5) into the LEFT and RIGHT UPRIGHTS(2, 3)
and secure with BUTTON HEAD BOLTS(M6x1x15mm)(36) and ARC WASHERS(M6)(41). Slide up the
FOAM GRIPS(22) to cover the screw heads.
STEP 4
Go back and tighten HEX BOLTS(M12x1.75x75mm)(35) in STEP 2. Connect the LOWER EXTENSION
WIRE(27) located on the LEFT UPRIGHT(2) to the SENSOR WIRE(28). Insert the PULL PIN(6) through
the RIGHT UPRIGHT(3) and BASE FRAME(1) to lock the BASE FRAME(1) in position.
Slide down the
upper parts of the
FOAM GRIPS(22)
for assembly.
8