Maintenance - Stamina T3000 Treadmill 45-1003 Owner's Manual

Stamina products, inc 45-1003 t3000 treadmill owner's manual
Table of Contents

Advertisement

TREADMILL ADJUSTMENTS
WALKING RESISTANCE
The walking resistance or effort needed to push the treadmill belt can be adjusted by changing the incline
angle. This treadmill has two adjustment positions.
Highest Resistance
The BUMPER STANDS(20) are attached to
the bottom of the treadmill.
NOTE:
1.
Since this is a new machine, you may need some time to get used to walking on the treadmill and to
break it in.
2.
If the walking resistance is still too high, check the BELT TENSION.
The belt resistance can be reduced by adding silicone lubricant between the belt and the board. Wipe
3.
the board under the belt with a cloth and spray or spread silicone lubricant on the board under the belt.

MAINTENANCE

The safety and integrity designed into the INMOTION
INMOTION
T3000 Treadmill
given to the following:
1.
Clean the exposed surfaces of the walking belt and the board with an absorbent cloth.
2.
It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
3.
Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts. Tighten
loose nuts and bolts.
4.
Verify that the Warning Label is in place and easy to read. Call Stamina Products immediately
(1-800-375-7520) for a replacement Warning Label if the Warning Label is missing or damaged.
5.
Worn or damaged components shall be replaced immediately or the INMOTION
removed from service until repair is made.
6.
Only Stamina Products supplied components shall be used to maintain/repair the INMOTION
Treadmill.
7.
Keep your INMOTION
8.
If the WALKING BELT(15) does not move easily, lubricate the BOARD(16) under the WALKING BELT(15)
with Silicone Lubricant.
is regularly examined for damage and wear. Special attention should be
T3000 Treadmill
clean by wiping with an absorbent cloth after use.
Lowest Resistance
Remove (unscrew) the BUMPER STANDS(20)
from the bottom of the treadmill and store them
in the end of the treadmill.
T3000 Treadmill
12
can only be maintained when the
T3000 Treadmill
T3000

Advertisement

Table of Contents
loading

This manual is also suitable for:

In motion t3000

Table of Contents