Table of Contents
Advertisement
28
electrolux.com.au
INSTALLATION
Positioning the machine
When considering the location for the dishwasher,
ensure that there is adequate space to enable loading
and unloading of the dishes.
•
Do not put your machine in any location where
the ambient temperature can fall below 5°C.
•
Before positioning, take the machine out of its
packaging by following the warnings located on
the package.
•
Position the machine close to a water tap and
drain. You need to position your machine, taking
into consideration that its connections will not be
altered once they are made.
•
Do not grip the machine by its door or panel in
order to move it.
•
Take care to leave a certain clearance from all sides
of the machine so that you can comfortably move
it back and forth during cleaning.
•
Make sure that the water inlet and outlet hoses do
not get squeezed while positioning the machine.
Also, make sure that the machine does not stand
on the electrical cable. Adjust the machine's feet
so that it is level and stable. Proper positioning of
the machine ensures problem-free opening and
closing of its door.
•
If the door of your machine does not close properly,
check if the machine is stable on the floor; if not,
adjust the feet and ensure it is level and stable.
Water connection
Ensure that the indoor plumbing is suitable for installing
a dishwasher and complies with AS/NZS 3500.1. Also,
we recommend that you fit a filter at the entrance of
your place or apartment so as to avoid any damage to
your machine because of any contamination (sand, clay,
with your machine. Before connecting the water inlet
hose to the water tap, ensure clean water is flowing
from the tap before making the connection. Connect
the water inlet hose directly to the water inlet tap. The
pressure supplied by the tap should be at a minimum
of 0.03 MPa and at a maximum of 1 MPa. If the water
pressure is above 1 MPa, a pressure-relief valve should
be installed.
rust etc) that might be occasionally
carried in through the main's water
supply or the indoor plumbing, and
to avoid problems of staining and
formation of deposits after washing.
Water inlet hose
Do not use the water inlet hose of
your old machine, you must use
the new water inlet hose supplied
WARNING
WARNING
Only turn the locking nut to secure hose –
do not turn the hose.
•
The first time you use the appliance, make sure that
there is no leakage.
•
The water inlet hose has a safety valve and a
sheath with an inner mains cable.
•
After the connections are made, the tap should be
turned on fully and checked for water tightness.
For the safety of your machine, make sure to
always turn off the water inlet tap after each wash
program is finished.
NOTE: Aquastop inlet hose has
components using 240V. Do not
cut Aquastop inlet hose. Do not let
it get folded, twisted, kinked
or crushed.
NOTE: A water tempering valve is
required if the water temperature
is over 60°C.
WARNING
CAUTION
Always use new hoses when you connect the
appliance to the water supply. Old hoses must
not be used. The water inlet hose must be
examined at an interval of twelve months for
deterioration and replaced if necessary.
In order to pass the safety valve through the
kitchen cabinets, an opening of at least 45mm x
90mm is needed.
WARNING
WARNING
WARNING
WARNING
30cm
min.
28
Advertisement
Table of Contents
