2 electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com CONTENTS Safety information Select and start a washing programme Product description Control panel Washing programmes Use of the appliance Care and cleaning Setting the water softener What to do if… Use of dishwasher salt Technical data Use of detergent and rinse aid...
Page 3
electrolux 3 • Do not fill the rinse aid dispenser with oth- Water connection er products than the rinse aid, (dishwash- • Use new hoses to connect the appliance er cleaning agent, liquid detergent). This to the water supply. Do not use used ho- can cause damage to the appliance.
4 electrolux • Do not replace or change the mains ca- – Discard the appliance at the local ble. Contact the service centre. waste disposal centre. • Make sure not to squash or cause dam- Warning! The dishwasher age to the mains plug and cable behind detergents are dangerous and can the appliance.
electrolux 5 CONTROL PANEL 4 5 6 On/off button Cancel button Programme selection buttons Multitab button Energy saver button Delay start button Display Function buttons Indicator lights Programme indicator lights Indicator lights It comes on when it is necessary to fill the salt container. Refer to 'Use of Salt dishwasher salt'.
6 electrolux Indicator lights Energy saver It comes on when you activate the energy saver function. Refer to 'Energy saver button'. 1) When the salt and/or rinse aid containers are empty, the related indicator lights do not come on while a washing programme operates.
electrolux 7 3. Fill the rinse aid dispenser with rinse aid. 7. Start the washing programme. 4. Load cutlery and dishes into the appli- If you use the combi detergent tablets ance. ('3 in 1', '4 in 1', '5 in 1'), use the multi- 5.
8 electrolux If the water softener is set electronically Example: the display shows = level to the level 1, the salt indicator light stays off. 6. Press the function button A again and again until the display shows the neces- sary adjustment.
electrolux 9 Do these steps to fill the rinse aid dispenser: Adjust the rinse aid dosage 1. Press the release button to open the Factory set: position 3. You can set the rinse aid dosage between of the rinse aid dispenser. position 1 (lowest dosage) and position 4 2.
10 electrolux SELECT AND START A WASHING PROGRAMME • Close the appliance door. Select and start a washing programme without delay start – The washing programme continues from the point of interruption. 1. Open the door. 2. Switch on the appliance. How to cancel a washing programme 3.
electrolux 11 Remove the items from the baskets • There can be water on the sides and on the door of the appliance. Stainless steel • Let the dishes become cold before you re- becomes cool more quickly than the move them from the appliance.
12 electrolux Energy (kWh) Water (litre) Programme 0,9 - 1,0 9 - 11 One hour 1,0 - 1,2 10 - 11 Rinse 1) The display shows the programme duration. The pressure and temperature of the and the quantity of dishes can change water, the variations of power supply these values.
electrolux 13 WHAT TO DO IF… The appliance does not start or stops dur- First try to find a solution to the problem (re- ing operation. fer to the chart). If not, contact the service centre. Malfunction Fault code Possible cause Possible solution The appliance does The display...
Page 14
14 electrolux The washing results and drying results are not satisfactory Problem Possible cause Possible solution The dishes are not clean. The selected washing pro- Make sure that the washing pro- gramme was not applicable for gramme is applicable for the the type of load and soil.
electrolux 15 7. Switch off the appliance to keep the op- eration. TECHNICAL DATA Dimensions Width 596 mm Height 850 mm Depth 620 mm Water supply pressure Minimum 0,5 bar (0,05 MPa) Maximum 8 bar (0,8 MPa) Cold water or hot water maximum 60 °C Water supply Capacity...
Page 16
16 electrolux How to remove the appliance worktop waste water from the sink goes back into the appliance. 1. Remove the rear screws (1). • A stand pipe with vent-hole. The internal diameter must be minimum 4 cm. max 85 cm min 40 cm 2.