Configuring Intellirupter Fault Interrupter Before Installation - S&C IntelliRupter PulseCloser Installation Manual

Con guring IntelliRupter Fault Interrupter Before Installation
To power both the protection and control module and
the communication module for pre-installation uploading
and downloading of con guration settings, plus radio
programming and battery charging, as applicable, use
S&C Power Supply catalog number TA-3221 only. After
installing both the protection and control module and
the communication module, as directed on page 14, attach
the power supply output cable to the connector on the
underside of the IntelliRupter fault interrupter base, near
the center pole-unit open/close indicator.
When finished, remove both modules before transport-
ing the IntelliRupter fault interrupter to the installation
site.
6
S&C Instruction Sheet 766-510
NOTICE
S&C Power Supply catalog number TA-3221 is
intended for indoor use only in the user's service
center.