Address Selector Rotary Dials; Status Indicator; Shift Key; Run/Stop Key - Digitrax UT1 Manual

3.3 Direction Toggle Switch
Flip to the right for forward direction and to the left for reverse direction.

3.4 Address Selector Rotary Dials

Rotate these two selectors to select the two digit address ( 00 to 98 ) of
the locomotive you wish to control. The left selector dials in the 10s
and the Right selector dials in the 1s. Select address "99" to select a
locomotive or consist that has been "DISPATCHED" from another
Digitrax throttle. (See section on dispatched locomotives.)

3.5 Status Indicator

Indicates the status of the UT1.
· Off indicates no locomotive is currently selected.
· Green indicates a locomotive has been successfully selected.
· Red indicates the direction and/or speed are out of correspondence
on a locomotive being selected.
· Blinking orange indicates the UT1 is in "Switch Mode".

3.6 Shift Key

· Press and hold to access F3, F4, F5.
· Press in conjunction with the ACQ button to "Dispatch"

3.7 Run/Stop Key

· Use as emergency stop. When held down will change locomotive
speed to "0". Turn throttle to "0" speed setting to regain control or
press RUN/STOP again.
· RUN/STOP key is used in conjunction with other keys to activate
other throttle functions.

3.8 ACQ/DISP Key

· Press to acquire any locomotive address after the address has been
dialed in with the rotary selectors.
· When address selector reads "99", press "ACQ/DISP" to acquire
locomotive address that has been dispatched by another throttle in
the system.
· If address selector is set to other than "99" press ACQ/DISP and
SHIFT to dispatch the locomotive address to another throttle in the
system.
· Press ACQ/DISP along with RUN/STOP to set Option Switches in
your booster.

3.9 F0/F3 Key

· Press F0 to toggle front and rear headlights on and off.
· Hold "Shift" and press F3 to toggle Function 3 on and off.
7