Becker Centronic SunWindControl SWC510 Assembly And Operating Instructions Manual page 23

Programming additional transmitters
In addition to the master transmitter, up to 15 further trans-
mitters can be programmed in the radio receiver.
Press the programming button of the master transmitter for 3 seconds.
▻ The receiver confirms.
Now press the programming button of a new transmitter which has not yet
been programmed in the radio receiver for 3 seconds. Doing so activates the
programming mode of the radio receiver for a new transmitter for 3 minutes.
▻ The receiver confirms.
Now press the programming button of the new transmitter you wish to pro-
gram again for 3 seconds.
▻ The receiver confirms.
► The new transmitter has now been programmed.
Deleting transmitters
Deleting individual transmitters
The programmed master transmitter cannot be deleted. It
can only be overwritten.
Press the programming button on the master transmitter for 3 seconds.
▻ The receiver confirms.
Now press the programming button of the transmitter to be deleted for 3
seconds.
▻ The receiver confirms.
Then re-press the programming button of the transmitter to be deleted for 10
seconds.
▻ The receiver confirms.
► The transmitter is now deleted from the radio receiver.
23 - en