Omicron Lab TICRO 100 Quick Start Manual page 19

3. If your computer is not connected via the USB port of TICRO 100: Connect your TICRO 100 to the
network your computer is connected to.
4. If necessary, install OMICRON Device Link on your computer. See chapter "OMICRON Device
Link" of the TICRO 100 User Manual.
5. Launch OMICRON Device Link.
6. OMICRON Device Link will automatically find and display your TICRO 100.
The vertical bar on the left displays the device status:
• Green bar: The device is online and ready for operation.
• Gray bar: The device is offline. Supply your TICRO 100 with power.
• Red bar: The device is online but not accessible due to incorrect IP configuration.
TICRO 100 is usually configured to obtain the IP address automatically. However, it is also
possible to assign a static IP address to TICRO 100. In this case, the following behavior applies:
When accessing TICRO 100 via Ethernet, OMICRON Device Link will find the TICRO 100, but
display a red bar to indicate that the device cannot be accessed.
► Click the TICRO 100 entry and select Configure IP.
OMICRON Device Link will then display an IP configuration page. In this page, select Use the
following IP address and enter the IP address of your TICRO 100, or enter an IP address of
your choice to assign a new IP adress to your TICRO 100. Click the Subnet mask field to
automatically fill a subnet mask and then click Apply to connect to TICRO 100.
Or
► Click the Add device button and enter the IP address assigned to TICRO 100.
OMICRON
Accessing the Web Interface
19