Table of Contents
Advertisement
TICRO 100 Quick Start Guide
3
Mounting
3.1
DIN rail mounting
Proceed as follows to mount TICRO 100 to a 35 mm DIN rail (acc. to EN 50022):
1. Place the DIN rail clip supplied on delivery to the rear side of TICRO 100 as shown in the figure
below and align it with the mounting holes. The spring side of the DIN rail clip must point towards
the DC power input socket!
2. Use the two M3x12 screws to fasten the DIN rail clip to TICRO 100 (TX10 screwdriver required).
Do not use other screws than delivered with the DIN rail clip!
3. Hook the spring side of the DIN rail clip to the top side of the DIN rail.
4. Press the device downwards and then towards the DIN rail until the clip audibly snaps onto the
DIN rail.
Proceed as follows to remove TICRO 100 from the DIN rail:
1. Compress the spring of the DIN rail clip by pressing TICRO 100 downwards.
2. Release the bottom side of the clip from the DIN rail and withdraw TICRO 100 upwards.
DIN rail clip with screws
DC power input socket
14
OMICRON
Advertisement
Table of Contents
