Accessing The Web Interface; System Requirements; Accessing The Ticro 100 Web Interface - Omicron Lab TICRO 100 Quick Start Manual

TICRO 100 Quick Start Guide
5

Accessing the Web Interface

TICRO 100 automatically powers up after supply voltage is applied. The green LED S1 lights up and
the red LED S2 is off when the device is ready for operation.
TICRO 100 can be configured and controlled completely via the Web Interface using a computer.
Under normal circumstances, no manual intervention at the device itself will be required.
5.1

System requirements

Your computer must fulfill the following requirements to access the TICRO 100 Web Interface:
• OMICRON Device Link installed (see chapter "OMICRON Device Link" of the TICRO 100 User
Manual).
OMICRON Device Link is always required for the initial access to TICRO 100. If a static
IP address is assigned to TICRO 100, the device can be accessed any time and from
any computer using this IP address.
• Web browser installed (Microsoft Edge, Mozilla Firefox 20 or higher, or Google Chrome version 31
or higher).
• For access via Ethernet network only:
Network port configured for operation in the network TICRO 100 is connected to.
• For access via USB only:
USB 2.0 port available. While accessing TICRO 100 via USB, the computer must not be
connected to the same Ethernet network TICRO 100 is connected to!
If you are accessing TICRO 100 from a Mac or Linux operating system supporting zeroconf,
you can access the Web Interface of TICRO 100 by entering http://<hostname>.local to the
address bar of your web browser. The default hostname is the device serial number. The
serial number is available on the type plate on the bottom side of TICRO 100 (labeled
"SerNo").
5.2

Accessing the TICRO 100 Web Interface

OMICRON Device Link is required for initial access to TICRO 100. If you know the IP
address of TICRO 100, it is alternatively also possible to access the device from a web
browser using its IP address (without using OMICRON Device Link).
Proceed as follows to access the TICRO 100 Web Interface using OMICRON Device Link:
1. Connect your computer to the network or to the USB port of TICRO 100.
(Please note: Access via the USB port may possibly be disabled in the TICRO 100 configuration
(see Access Restrictions tab in section "Security configuration page" of the TICRO 100 User
Manual)).
2. Supply your TICRO 100 with power (see
18
Power supply on page 16).
OMICRON