Before Operation Safety; During Operating Safety - Toro HoverPro 400 Operator's Manual

Before Operation Safety

General Safety
•
Become familiar with the safe operation of the
equipment, operator controls, and safety signs.
•
Check that all guards and safety devices are in
place and working properly.
•
Always inspect the machine to ensure that the
cutting unit bolt, line, and disc are not worn or
damaged.
•
Inspect the area where you will use the machine
and remove all objects that the machine could
throw.
•
Adjusting the cutting height may bring you into
contact with the moving cutting disc, causing injury.
– Shut off the engine and wait for all moving
parts to stop.
– Disconnect the spark-plug wire from the spark
plug before adjusting the cutting height.
Fuel Safety
DANGER
Fuel is extremely flammable and highly
explosive. A fire or explosion from fuel
can burn you and others and can damage
property.
• To prevent a static charge from igniting the
fuel, place the container and/or machine
directly on the ground before filling, not in
a vehicle or on an object.
• Fill the fuel tank outdoors, in an open area,
when the engine is cold. Wipe up any fuel
that spills.
• Do not handle fuel when smoking or
around an open flame or sparks.
• Store fuel in an approved container and
keep it out of the reach of children.
WARNING
Fuel is harmful or fatal if swallowed.
Long-term exposure to vapors can cause
serious injury and illness.
• Avoid prolonged breathing of vapors.
• Keep your hands and face away from the
nozzle and the fuel-tank opening.
• Keep fuel away from your eyes and skin.

During Operating Safety

General Safety
•
Wear appropriate clothing, including eye
protection; slip-resistant, substantial footwear; and
hearing protection. Tie back long hair, and do not
wear jewelry.
•
Do not operate the machine while ill, tired, or
under the influence of alcohol or drugs.
•
The cutting unit is sharp; contacting the disc or line
can result in serious personal injury. Shut off the
engine and wait for all moving parts to stop before
leaving the operating position.
•
When you release the operator-presence control,
the engine should shut off and the cutting unit
should stop within 3 seconds. If not, stop
using your machine immediately and contact an
Authorized Service Dealer.
•
Operate the machine only in good visibility and
appropriate weather conditions. Do not operate
the machine when there is the risk of lighting.
•
Wet grass or leaves can cause serious injury if you
slip and contact the cutting unit. Mow only in dry
conditions, if possible.
•
Use extreme care when approaching blind
corners, shrubs, trees, or other objects that may
block your view.
•
Watch for holes, ruts, bumps, rocks, or other
hidden objects. Uneven terrain could cause a
slip-and-fall accident.
•
Stop the machine and inspect the cutting unit
after striking an object or if there is an abnormal
vibration in the machine. Make all necessary
repairs before resuming operation.
•
Before leaving the operating position, shut off the
engine and wait for all moving parts to stop.
•
If the engine has been running the muffler will be
hot and can severely burn you. Keep away from
the hot muffler.
•
Use accessories and attachments approved by
The Toro® Company only.
3